|
|
 |
|
The Control Box
Step
4
PURPOSE:
To wire the pole switches (port and starboard thrusters)
MATERIALS:
- 2 pole switches
- Prepared control box
- Solder
TOOLS:
|
|
PROCEDURE:
- Refer to Figures 20 and 21 (next page) for instructions
on wiring pole switches.
- Cut four small pieces (1 1/4") from one
of the left
over loose wires. Solder them to opposite
corner terminals
of the pole switches. (Fig21A)
- The pole switch terminals are arranged into 2 columns
with 3 terminals in each column. Use the RIGHT column
for positive (+) connections and use the LEFT
column for negative
(-) connections.
- Separate about 2" from the blue (+) and green
(+) wire pairs. Solder the blue (+) positive wire
to the bottom
right terminal on your FIRST pole switch. Repeat
with green (+) wire for the SECOND
switch. (Fig 21B).
- Solder one white wire to each of the terminals on the
bottom left side of each switch. (Fig 21B)
- Solder the Power wire splices to the middle terminals:
Solder one red (+) wire splice to each of the
middle-right
terminals. Solder one black (-) wire splice to
each of the
middle-left terminals. (Fig 21C)
 |
| |
|
|
 |
|
 |
A. Cross wired pole switch
|
|
B. Cross wired pole switch with tether connection
|
|
|
|
| C. Cross wired pole switch with tether and power cable connections |
|
|
|
|
|